# 04. Adjustable trellis tensioner **PROTOTYPE / NOT PHYSICALLY TESTED** Hand-wound cord spool with twelve positive locking positions and an integrated cord guide. All modeled dimensions are in millimeters. These are original prototype geometries, not verified fits to your existing equipment. ## Print list | STL | Quantity | Notes | |---|---:|---| | `stl/base.stl` | 1 | 100 x 76 x 24 mm; flat face down. | | `stl/spool.stl` | 1 | 50 mm lower flange; flange down; M5 axle and twelve 4.5 mm lock holes. | | `stl/lock_pin.stl` | 1 | Optional printed fit-check pin; head down for printing, invert for assembly. | ## Hardware to supply - 1 x M5 x 40 mm hex-head bolt, head across flats 8 mm; verify head fits 8.9 mm AF recess. - 1 x M5 nyloc nut and 2 x M5 washers; use one ~1 mm nylon washer under the spool. - 1 x smooth 4 mm steel drop pin, 9-10 mm usable length, with a removable head/handle (preferred over printed lock pin). - Plant-support cord 1.5-2.5 mm diameter; cable ties or appropriate M4 mounting screws for your frame. ## Assembly 1. Secure the base to a rigid trellis using the two cable-tie slots or four mounting holes; mounting hardware depends on the frame. 2. Insert the M5 bolt from below into the hex recess. Place a roughly 1 mm nylon washer above the base, then the spool and top washer/nut. 3. Tighten the nyloc nut only until axial play is controlled; the spool must rotate freely and cannot be clamped solid. 4. Pass cord through the guide, around the drum, then through the offset 3.5 mm cross-hole. Tie a stopper knot outside the drum. Keep cord away from axle and pin holes. 5. Wind by hand, align a lower-flange hole with the single base locking hole, and insert the drop pin completely through both. 6. To release, hold the spool, remove the pin, then unwind slowly by hand. ## Starting print settings - Use PETG as a starting material; 0.20 mm layers, 4 walls, 35% infill. - Print each supplied STL in its existing orientation; the small horizontal holes may need light cleanup. - The 45-degree upper flange reduces unsupported overhang; inspect the spool in the slicer. - The optional pin is a fit-check part; use a steel pin for service. ## Limits and fit checks - PROTOTYPE / NOT PHYSICALLY TESTED. - No load rating. For light plant-support net/cord tension only; not for lifting, fall protection, structural bracing, or overhead loads. - Nominal rotary clearance depends on printing and washer thickness. Remove burrs and test operation before attaching plants. - The guide center is 18 mm above the base bottom; the spool drum spans approximately 11-23 mm assembled. ## Edit and regenerate Open `design.scad` in OpenSCAD. Choose the `part` selector and use Render (F6), then Export STL. Command-line example: ```bash openscad -o stl/base.stl -D 'part="base"' design.scad ``` `part="preview"` displays the assembly; it is not a print plate. The STL files supplied above are the individually printable components. Parameters at the top of the source control the main fits; verify all mating geometry after any edit.