Divider feet ============ Category: Room dividers Default units: millimeters Recommended material: PETG Design intent: Weighted slot foot for 4 mm panel Print baseline: - 0.4 mm nozzle - 0.20 mm layer height - 3 to 4 perimeters - 20-35% infill for brackets / 10-20% for light-duty organizers - PETG preferred around water, heat, fans, pumps and structural joints - Typical fit clearance used across the library: about 0.35 mm Customization: Open divider_feet.scad in OpenSCAD. The final module call is at the bottom. Change dimensions there and export a new STL. Safety / engineering note: This is a printable prototype, not a certified pressure, electrical, load-bearing, food-contact, or life-safety component. Verify fit, drainage, electrical isolation and mechanical loads for your setup before relying on it.