Square 12-inch modular growing pot.
12-inch square pot with a 1-inch drainage base and repeatable 1.5-inch stackable extenders. Print one base and add extenders to set the height.
INTERACTIVE 3D PREVIEW
See it from every angle.
Loading 3D preview…
Drag to rotate · Scroll to zoomMODULAR GROWING POTS / BUILD YOUR HEIGHTStart with a base.
Start with a base.
Stack to grow.
Print one drainage base, then add as many matching extenders as your setup needs. Each extender overlaps the section below by 6 mm.
External side length12 in304.8 mm
Drainage base1 in25.4 mm tall
Each extender1.5 in38.1 mm tall
Added height32.1 mmper extender after overlap
How to assemble
- Print one base and the number of extenders you want.
- Fit an extender onto the base, then stack additional extenders using the same joint.
- Check the fit and stability before filling with wet growing medium.
- Use a saucer indoors; drainage holes are in the base.
Wall thickness: 3.2 mm. Base plus one extender: 57.5 mm tall.
Print notes
- print 1 base and as many extenders as needed.
- Recommended upright orientation, 0.2 mm layers, 3-4 walls, PETG for reuse.
- No supports should be necessary, though print a fit test first.
- Drainage holes are in the BASE; add a saucer for indoor use.
- Check stack stability before loading with wet growing medium.
- Bambu P1S: 11 and 12 inch footprints exceed 256 mm bed; 10 inch is very close to its limit.
The supplied STL meshes passed watertight geometry checks. Physical fit, drainage, and stability still need testing with your printer and growing medium.