Leaf inspection platform.
A 150 x 100 mm inspection stage with 100 mm recessed ruler, sliding soft-contact fingers, backlighting aperture and removable background plate.

INTERACTIVE 3D PREVIEW
See it from every angle.
Loading 3D preview…
Drag to rotate · Scroll to zoomPLANT WORKSHOP / PROTOTYPE
Make and assemble.
All dimensions are in millimeters. These designs have passed digital mesh checks but have not been physically printed or tested. Check fit, water resistance, and load capacity for your setup.
Parts to print
- platform × 1Flat face down as exported; 150 x 100 x 6 mm.
- finger × 2Print two identical fingers; 46 x 14 x 3.2 mm. Add soft pads at tips.
- spacer × 2Two 2 mm spacers; 4.6 mm clearance hole.
- backing × 1Loose 70 x 42 x 2 mm background card; slide below the aperture.
Additional components
- 2 x M4 x 20 mm machine screws, 2 x M4 wing nuts, 4 x M4 washers.
- 2 x soft silicone or foam pads, about 8 x 8 x 2 mm, for finger tips.
- 4 x adhesive rubber feet at least 6 mm tall to clear the screw heads.
Assembly
- Add the rubber feet to the underside corners. Pass an M4 screw upward through each long slot, with washer below the platform.
- Fit one 2 mm spacer, one finger, one washer and a wing nut to each screw. Finger pivots lie above the two slots, at y = -34 and +34 mm.
- Rotate fingers toward the aperture. Add soft pads to the underside of the tips. Slide pivots along their slots to suit the specimen.
- Rest a detached leaf or an easily supported leaf on the stage, use only light contact, and tighten wing nuts just enough to keep position. The fingers are position holders, not spring clamps.
- Use the loose backing card below the aperture for an opaque background, or remove it for an external light source.
Print notes
- Suggested starting point: PETG or PLA for dry indoor use, 0.20 mm layers, 4 walls, 20-30% infill.
- All parts have their intended flat print orientation in the STL. No supports intended. Print finger.stl and spacer.stl twice.
- Measure the 100 mm scale after printing; treat it as a reference until checked against a ruler.
Limitations
- Prototype, not physically tested. Verify slot fit and screw-head clearance.
- Soft pad thickness and spacer height control the leaf gap. Avoid squeezing or puncturing leaves.
- The holder does not include a camera, magnifier or light. It is not a precision measuring instrument.