3D PRINTABLE MODEL / Plant Workshop expansion

Modular workbench wash station.

A compact manual-emptying wash basin, lift-out draining basket, fine strainer and removable splash shield for potting tools.

CAD preview of Modular workbench wash station
Rendered CAD preview · prototype design
INTERACTIVE 3D PREVIEW

See it from every angle.

Loading 3D preview…

Drag to rotate · Scroll to zoom
PLANT WORKSHOP / PROTOTYPE

Make and assemble.

All dimensions are in millimeters. These designs have passed digital mesh checks but have not been physically printed or tested. Check fit, water resistance, and load capacity for your setup.

Parts to print

  • basin × 1224 x 175 x 42 mm including rear shield receivers; 3 mm floor/walls.
  • basket × 1224 x 164 x 37 mm with handles. Basket bottom sits 18 mm above the basin bottom when assembled.
  • strainer × 184 x 64 x 18 mm. 2.5 mm drainage holes, separate small-parts strainer.
  • splash panel × 1210 x 92 x 3 mm. Print flat; includes two 12 mm-wide locating tongues.

Additional components

  • Optional: 4 x rubber feet for the basin.
  • Optional: removable finer mesh for the strainer if smaller debris must be retained.

Assembly

  1. Print and clean the basin, basket, strainer and splash panel. Remove strings from every drain hole.
  2. Insert the splash panel tongues downward into the two rear receivers. Nominal tongue thickness is 3.0 mm; slots are 4.2 mm deep across the thickness and 12.6 mm wide.
  3. Lower the basket into the basin. Its 224 x 164 mm lip rests on the basin rim, leaving a sump beneath.
  4. Place the small strainer in the basket for washing small tools or catching debris from a poured rinse.
  5. Keep collected water below the basket floor, lift the basket to drain, remove the shield and manually empty the basin. This design has no hose outlet.

Print notes

  • PETG starting point: 0.20 mm layers, 5 walls, 6 bottom layers, 25% infill. These settings do not guarantee leak resistance.
  • Basin, basket and strainer print upright as exported. Splash panel prints flat.
  • Basket handles contain two 20 mm bridges. Inspect the sliced bridge paths and enable local supports if your filament/profile needs them.
  • The largest footprint is 224 x 175 mm, leaving room on a 256 mm P1S plate. Check actual brim/keep-out areas in your slicer.

Limitations

  • Prototype, not physically tested. Leak-test the basin over a sink before use.
  • Intended for cool water and ordinary potting tools. No chemical-compatibility or sanitation claim is made.
  • Do not lift the assembly by the shield. Carry the basin from underneath and empty it before moving.
  • Preview is exploded: the real basket floor sits at z = 18 mm and its lip rests at z = 42 mm.